| |
 Permanent lube oil filtering Top side adjustment of seaming chucks Quality control belt behind the CAN-O-MAT Motorised height adjustment New upper spindle drive Spindle sleeve pressure testerQuality control belt behind the CAN-O-MAT |
The test can ejector makes it possible to select individual cans or an entire production
sequence and eject them at the CAN-O-MAT outfeed for quality control purposes without any
drop in production speed.
With a push on a button at the panel the system is activated, and 8 cans, for example, are ejected. The first can is always formed in tool no.1, so there is a direct relation between can and tool. The ejected cans can be evaluated manually or transferred to an automatic testing or inspection machine. This unit is available for all CAN-O-MATs with Siemens or Allan Bradley PLC and with an integrated display panel, which was introduced in 1994. |
The discharge belt behind the CAN-O-MAT will be replaced by a new belt, 2 m long, with the quality ejection belt branching off at a specific angle, and the additional equipment for the can ejection. If necessary the existing discharge belt must be shortened.
One sensor must be installed in the CAN-O-MAT and some other electrical wiring to the electrical cabinet must be done. The PLC program must be updated. Compressed air is necessary for the can ejector. |
 |
|
| Retrofits: Permanent lube oil filtering Top side adjustment of seaming chucks Quality control belt behind the CAN-O-MAT Motorised height adjustment New upper spindle drive Spindle sleeve pressure tester |
