| |
 Permanent lube oil filtering Top side adjustment of seaming chucks Quality control belt behind the CAN-O-MAT Motorised height adjustment New upper spindle drive Spindle sleeve pressure testerMotorised height adjustment |
Most CAN-O-MAT stations are equipped
with the tried-and- tested height adjustment
system
operated by hand-wheel. To reduce resetting times even further, the hand-wheel is replaced
by a gear motor with measuring
device. By entering a preset height, settings
are made automatically. In addition, a
quick-lift function has been integrated as well, which is helpful
when taking out damaged
cans after a jam and during maintenance or changeover.
|
 |
 |
This retrofit unit is available for all CAN-O-MAT I with Siemens PLC type S7, with integrated display panel OP 17 and for all forming units with the cross roller bearing XU 120 179 at the top position. The following units meet these conditions: |
| Type of unit | Beginning with drawing number | Beginning with year of construction |
| Die necking | DVko-39.00.012 - | January 1994 |
| Spin flanging with upper cam | DVko-52.00 010 - | January 1994 |
| Spin flanging without upper cam | DVko-35.00 023 - | October 1996 |
| Swing flanging with upper cam | DVko-53.00.001 - | January 1998 |
| Swing flanging without upper cam | DVko-54.00.001 - | April 1998 |
| Rail seaming | DVko-33.00.032 - | August 1996 |
| Roll seaming | DVko-36.00.001 - | January 2001 |
| Attention - for all CAN-O-MAT I with cover hood : An additional height of 270 mm on top of the unit is required. |
|
Retrofits: Permanent lube oil filtering Top side adjustment of seaming chucks Quality control belt behind the CAN-O-MAT Motorised height adjustment New upper spindle drive Spindle sleeve pressure tester |
