Conventional parting with preflange:
Multiplying the output of the welding bodymaker

Parting system for prescored bodies producing a preflange during the parting process.
Output significantly increased by parting two-high welded bodies.
Production of very small can heights.
Guaranteed clean parting of DR bodies proven down to 0.12 mm ( #43 ).
Precision parting of lacquered and powder seam coated bodies.
   
Single outfeed with separating  
   
The upper body halves are separated and lowered to the level of the bottom halves in a controlled process.
The separation can be done in the outfeed star (up to medium speed) or in an additional separating station (for high speed or critical can sizes).

Double outfeed  
The upper and lower body halves exit the parting machine via two outfeeds at different levels.
The two outfeeds can link to two different backends.
The body halves of one exit can be turned over in order to have all pre-flanges at one side. These bodies can be die necked at the straight end.
Double outfeed is only possible in stand alone machines.


Information:  Basic technical conditions
  Material conditions for parting with preflange . ( pdf   )
  Powder application for parting and necking. ( pdf   )
Technical Data:  
CAN-O-MAT I   parting with preflange
  4 spindles
1 or 2 exits		 6 spindles
1 or 2 exits		 8 spindles
2 exits only
 Body diameter 52 – 105 mm 52 – 73 mm 52 – 105 mm
 Body height 30 - 125 x 2 mm 30 - 125 x 2 mm 30 - 125 x 2 mm
 Sheet thickness 0,13 – 0,25 mm 0,13 – 0,25 mm 0,13 – 0,25 mm
 Max. capacity in/out 400/800 cpm 600/1200 cpm 800/1600 cpm

 Technical Data:(all CAN-O-MAT processes)